Sorry if this has been posted some where, I did a number of searches and couldn't find anything.
I have a 1993 Lance Squire Camper that I'm replacing the old crank jacks with new electric ones from Atwood. These are not remote control, the switches are on the jacks. The two front ones run in tandem and the two backs ones do the same.
I assume that the camper was not pre wired for electric jacks, though that would be sweet. Anyone done this before? Any tips on where to run the wires? I'm pretty handy, I just don't want to start drilling holes etc. Until and get some clarity on what is the best approach.
thanks,
Jeff
Powered by Invision Power Board (http://www.invisionboard.com)
© Invision Power Services (http://www.invisionpower.com)